Коды неисправностей фронтального погрузчика CASE
CODE DEFINITION
- 12110 Engine coolant temperature is 110° C (230° F) or greater
- 12900 Engine coolant temperature sensor short circuit measuring less than 50 ohms.
- 12901 Engine coolant temperature sensor open circuit measuring greater than 10,000 ohms with hydraulic oil temperature at 40° C (104° F) or more, indicated by a resistance of 1463 ohms or less.
- 13000 Low engine coolant level - This code will not be generated if the engine coolant temperature is below 20° C (68° F).
- 21070 Engine oil pressure is measured below 70 kPa (10 psi)
- 21900 Engine oil pressure sensor short circuit measuring less than 16 ohms and engine coolant temperature is greater than or equal to 70° C (158° F).
- 21901 Engine oil pressure sensor open circuit measuring more than 270 ohms.
- 33900 Fuel level sender short circuit measuring less than 16 ohms.
- 33901 Fuel level sender open circuit measuring more than 270 ohms.
- 34000 Short circuit in fuel solenoid circuit.
- 35000 High air filter restriction.
- 42125 Transmission temperature measured above 125° C (257° F)
- 45000 High transmission filter restriction when the transmission oil is above 20° C (68° F).
- 46017 Gear range fault error
- 46018 Logical error at direction select signal
- 46020 Logical fault at park brake status
- 46021 Logical error at FNR switch
- 46023 Short circuit to ground at ride control 46024 Short circuit to battery voltage at ride control
- 46025 Open circuit at ride control
- 46037 Short circuit to battery voltage or open circuit at temperature sensor
- 46038 Short circuit to ground at temperature sensor
- 46039 Short circuit to battery voltage or open circuit at converter output temperature sensor
- 46040 Short circuit to ground at converter output temperature sensor
- 46049 Short circuit to battery voltage or open circuit at engine speed sensor
- 46050 Short circuit to ground at engine speed sensor 46051 Logical error at engine speed sensor input
- 46052 Short circuit to battery voltage or open circuit at turbine speed sensor input 46053 Short circuit to ground at turbine speed sensor input
- 46054 Logical error at turbine speed sensor input
- 46055 Short circuit to battery voltage or open circuit at intermediate speed sensor input 46056 Short circuit to ground at intermediate speed input
- 46057 Logical error at intermediate speed sensor input
- 46058 Short circuit to battery voltage or open circuit at output speed sensor
- 46059 Short circuit to ground at output speed sensor 46060 Logical error at output speed sensor
- 46062 Output speed zero, does not match other speeds.
- 46064 Invalid gear range restriction (CAN)
- 46065 Invalid declutch modulation selection (CAN)
- 46089 Invalid test mode signal (CAN)
- 46090 Invalid park brake status (CAN)
- 46091 Invalid shift quality selection (CAN)
- 46113 Short circuit to battery voltage at clutch K1
- 46114 Short circuit to ground at clutch K1
- 46115 Open circuit at clutch K1
- 46116 Short circuit to battery voltage at clutch K2
- 46117 Short circuit to ground at clutch K2
- 46118 Open circuit at clutch K2
- 46119 Short circuit to battery voltage at clutch K3
- 46120 Short circuit to ground at clutch K3
- 46121 Open circuit at clutch K3
- 46129 Short circuit to battery voltage at clutch K4
- 46130 Short circuit to ground at clutch K4
- 46131 Open circuit at clutch K4
- 46132 Short circuit to battery voltage at clutch KV
- 46133 Short circuit to ground at clutch KV
- 46134 Open circuit at clutch KV
- 46135 Short circuit to battery voltage at clutch KR
- 46136 Short circuit to ground at clutch KR
- 46137 Open circuit at clutch KR
- 46145 Short circuit to ground at backup alarm relay 46146 Short circuit to battery voltage at backup alarm
- relay
- 46147 Open circuit at backup alarm relay
- 46177 Slippage at clutch K1
- 46178 Slippage at clutch K2
- 46179 Slippage at clutch K3
- 46180 Slippage at clutch K4
- 46181 Slippage at clutch KV
- 46182 Slippage at clutch KR
- 46183 Oil temperature at valve body is above limit
- 46185 Engine speed is measured above 5,000 rpm for 0.2 seconds
- 46186 TCU sensed a voltage at oil filter maintenance switch out of the allowed range (dirty filter)
- 46195 Oil temperature at converter output is above limit
- 46196 Short circuit to ground at transmission enable switch indicator circuit 46197 Short circuit to battery voltage at transmission enable switch indicator circuit
- 46198 Open circuit at transmission enable switch indicator circuit
- 46209 Short circuit to battery voltage at power supply for sensors 46210 Short circuit to ground at power supply for sensors
- 46211 Low voltage at battery 46212 High voltage at battery 46213 Error at switch 1 for solenoid power supply 46214 Error at switch 2 for solenoid power supply
- 46227 Short circuit to battery voltage at display output
- 46228 Short circuit to ground at display output 46229 Error at communication on CAN
- 46230 Undefined VIN request via CAN.
- 46241 General EEPROM fault 46242 Current ID not set or corrupt
- 46243 Application error (ZF internal) 46245 Clutch calibration fault 46246 Clutch adjustment data lost 47000 CAN interface failure where no signals are received over one second of time
- 47001 Engine speed is missing 47002 Output shaft speed is missing
- 47011 Transmission oil temperature is missing
- 47012 Transmission filter restriction information is missing
- 47013 Current VINS is outside of the range 47014 Result code (11)
- 51000 Low steering pressure has been detected after a normal operating pressure has been reached since start up.
- 61000 Low brake pressure (1700 PSI / 11721 kPa) has been detected after a normal operating pressure has been reached since start up.
- 61900 1700 PSI (11,721 kPa) Brake pressure switch has not cycled within 50 hours of operation time.
- 61901 900 PSI (6250 kPa) Redundant brake pressure switch has not cycled within 100 hours of operation time.
- 64000 Park brake solenoid output short circuit. 66900 Park brake switch has not cycled within 50 hours of operation time.
- 66901 Service brake foot switch has not cycled within 50 hours of operation.
- 72110 Hydraulic oil temperature is 110° C (230° F) or greater.
- 72900 Hydraulic oil temperature sensor short circuit measuring less than 50 ohms.
- 72901 Hydraulic oil temperature sensor open circuit measuring greater than 10,000 ohms with the engine coolant temperature at 90° C (194° F) or more, indicated by a resistance of 243 ohms or less.
- 74000 Pilot pressure solenoid output short circuit.
- 75000 High hydraulic filter restriction when the hydraulic oil is above 20° C (68° F).
- 84018 System voltage is below 18 volts.
- 84032 System voltage is above 32 volts.
- 86010 Corrupt engine hours, data lost
- 86020 Corrupt tire calibration numbers, data lost – The calibration number will default back to the number used at cluster shipment
- 86040 Information Center program memory error
- 86050 Information Center RAM failure
- 86060 Information Center Reset – This code is generated if the Information Center Program “goes astray”. The Information Center is reset. This code will also be generated if there is a brief intermittent open between the time the engine is shut off and the Information Center shuts off.
- 86070 Open range setting
- 86071 Brightness setting
- 86072 Machine ID
- 86073 Machine info
- 86075 Cluster date code
- 86076 Cluster reserved
- 86077 Calibration number
- 86078 Shift quality
- 86079 Requested Gmin
- 86080 Requested Gmax
- 86081 Declutch modulation
- 86082 Creep setting
- 86083 Service hours
- 86084 Diagnostics stack pointer (internal to software)
- 86085 Diagnostics stack contents
- 86086 Digital input states (internal to software)
- 86087 Engine hour time stamps for digital input
- states (internal to software)
- 91000 Air Conditioning high or low pressure indication
ENGINE FAULT CODE CHART
BLINK CODE | DEFINITION | LAMP STATUS |
1.2 | Multiple State Switch | Off |
1.4 | Accelerator Pedal Signal | On |
1.8 | Diagnostic Lamp | Off |
2.1 | Coolant Temperature Signal | On |
2.2 | Boost Temperature Signal | Off |
2.3 | Fuel Temperature Signal | Off |
2.4 | Boost Pressure Signal | On |
2.5 | Atmospheric Pressure Signal | Off |
2.6 | Oil Pressure Signal | On |
2.7 | Oil Temperature Signal | On |
2.8 | Power Stage Fuel Filter Heater | Off |
3.7 | On | |
3.8 | Ls Power Stage Cold Start Lamp | Off |
3.9 | Cold Start Heater Monitoring | Off |
5.1 | Injector Solenoid Valve Cylinder 1 | On |
5.2 | Injector Solenoid Valve Cylinder 2 | On |
5.3 | Injector Solenoid Valve Cylinder 3 | On |
5.4 | Injector Solenoid Valve Cylinder 4 | On |
5.5 | Injector Solenoid Valve Cylinder 5 | On |
5.6 | Injector Solenoid Valve Cylinder 6 | On |
5.7 | Injector Booster Voltage C1 | On |
5.8 | Injector Booster Voltage C2 | On |
6.1 | Increment Speed Signal | On |
6.2 | Segment Speed Signal | On |
6.3 | Engine Speed Sensing | On |
6.4 | Engine Overspeed | Flashing |
6.5 | Hs Power Stage 8 For Starter Control | Off |
8.1 | Fuel Pressure Monitoring Cp3 | Flashing |
8.2 | Fuel Pressure Signal | Flashing |
8.3 | CC HS Power Stage 1 Fuel Pressure Control | Flashing |
8.4 | Monitoring Of Rail Pressure Relief Valve | Flashing |
8.5 | Fuel Pressure Monitoring CP3 (High) | Flashing |
9.4 | Main Relay Defect | On |
9.6 | ECU Self Test Shutoff Paths | On |
9.7 | Power Supply For Sensors | On |
Note 1 - System Degradation: 1 = 0% Derate 2 = Moderate Derate 3 = Significant Derate 4 = Engine Stop |